Bed Couches Design

Wood Futon Bed Designs Target

Futon Bed Designs Target – You can spend a considerable amount of money on a commercially-produced folding futon frame, one containing the controls or hinges to convert the bed to a sofa. Even building a frame like this is beyond the ability of most people who work on furniture as a hobby, you can put together an easier “studio” frame using standard household tools and mess from a local home improvement center. Set off a whole day for this project, including time for your color drought. Cut all wood to the right dimensions eight 2 by 4-inch pieces 28 inches long, two 2 by 4-inch 36 inches long and eight 1 by 6-inch lamellas 79 inches long. These measurements are for a full-size futon mattress. Adjust dimensions to fit the size of the mattress.

Drill a hole through all your wooden futon bed designs target beams. Use a drill bit with the same diameter as your wooden screws. Place the hole on the center line of the beam, one inch from one end. Drill a second hole on the opposite end of two of your wooden beams, even placed on the center line, 1 inch from that end. Sand all the faces in your wood until the wood is smooth enough to drive a finger without feeling any degrees or ridges.

Paint all surfaces in your wood futon bed designs target. This makes the frame more attractive, and it protects your mattress from wearing the wood. Allow it to dry completely and add a second layer. Pair your 28-inch beams and attach them by sending a backbone bolt through the holes and pulling down the wing nut. See the two beams with two holes in them are not connected to each other. Position the beams on the ground, parallel and with the ends line. They should lie straight, instead of bending at the joint. Make sure the two beams with an extra hole have the hole on the same side, and the beams are at the outer edge of the arranged beams.

Comments are closed.